How to Program the Remote Key Less Entry for Your Ford Mondeo
Tips and Tricks for Programming the Ford Mondeo RKE Keyfob. Step-by-Step Instructions for Programming the Ford Mondeo RKE Remote Keyless Entry. This tutorial will work for the following year models: 1996, 1997, 1998, 1999, 2000. Please follow the instructions below.
- Enter Programming Mode – Step 1
INSERT key into ignition and TURN from OFF to RUN/ACC.
OFF is the position where you can remove your key, RUN/ACC is the position just shy of starting your vehicle.
- Enter Programming Mode – Step 2
LOCATE the Programming Connector located behind the Glove Box Compartment.
The Programming Connector consists of 2 wires and a plastic plug terminator with 2 pins.
The pins will NOT be connected to anything.
- Enter Programming Mode – Step 3
JUMP the 2 pins in the Programming Connector using a suitable metal jumping wire (example – paperclip).
- Program Remote
PRESS any button on the remote to be programmed.
Door locks will cycle Lock/Unlock to confirm successful programming of the remote.
REPEAT this step IMMEDIATELY for any other remotes to be programmed to your vehicle.
- Exit Programming Mode
TURN ignition to OFF to exit Programming Mode.
The vehicle locks will cycle Lock/Unlock to indicate successful completion of programming.
- Test Remotes
Test all remotes. Programming is now complete.
Important:
- Verify the following prior to following these instructions:
- Your vehicle is equipped with keyless entry, and
- You have a key fob remote that is compatible with your vehicle.
- Obtain all remote transmitters for this vehicle. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the vehicle at this time.
- You may clear your keyless entry system memory by entering programming mode as shown in the steps above.
Note: If your vehicle cannot enter programming mode, then you cannot program any remote. This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module.
I really hope that you’ll find this tutorial useful in programming the key fob for your Ford Mondeo Aspen, LX, Verona, GLX, Si, Zetec, Zetec-S, Ghia, Ghia X,ST24,ST200. A Guide to Programming the Ford Mondeo RKE Keyfob, Including Hints and Tips Instructions in Detail for Programming the Ford Mondeo RKE Remote Keyless Entry System (Step-by-Step Guide) The following years’ models are compatible with this tutorial: 1996, 1997, 1998, 1999, and 2000. Please make sure to follow the instructions that are listed above.
Thank you very much! This tutorial was compiled and researched with ❤️ by Erwin Salarda.
TAGS:
Program Your Ford Mondeo’s Keyfob in Less Than 5 Minutes, How to Program the Remote Key Less Entry for Your Ford Mondeo, Tips and Tricks for Programming the Ford Mondeo RKE Keyfob, Step by Step Instructions for Programming the Ford Mondeo RKE Keyfob, Helpful Hints for Programming the Ford Mondeo RKE Keyfob, Forgot How to Program Your Ford Mondeo RKE Keyfob? No Problem!, How to Easily Program Your Ford Mondeo RKE Keyfob