How To Change The Trailer Brake Type Of Toyota Tundra
The 3 Simple steps as your guide on how to change the trailer brake type of your Toyota Tundra. Please follow the instruction below.
It is the responsibility of the driver to make sure the trailer brakes are functioning normally and adjusted appropriately. Failure to check and maintain trailer brakes may result in loss of vehicle control, crash, or serious injury. Trailer brake control system will work with most electric and electric-over hydraulic trailer braking systems up to 3 axles (24A output to trailer brakes). Please be sure to test compatibility with the system at low speeds and in a safe area. If a warning message appears in the multi-information display, have the vehicle inspected by your Toyota dealer immediately. Some electric-over-hydraulic trailer brakes will take some minimum output to activate. Trailer brake control system will not work with trailer hydraulic surge brakes.
The trailer brake type can be selected on the multi-information display as following:
STEP 1
- Press “left” or “right” button of meter control switches and select SETTINGS.
STEP 2
- Press “up” or “down” button of meter control switches and select “VEHICLE SETTINGS”, and press OK (dot) button .
STEP 3
- Press “up” or “down” of meter control switches and select “TBC Trailer Type”, and press OK (dot) button to select the correct type of trailer brakes that are equipped on the trailer.
Changing trailer brake type will cause the current gain setting to reset to zero. Make sure to set the gain. Read Here: How To Adjust The Trailer Brake Gain
That’s all the information you need to know to change the trailer brake type of your Toyota Tundra pickup. Thank you very much for visiting my website. Erwin C. Salarda