2004-2019 Mazda TPMS Reset Instruction

TPMS Reset for the following Mazda Model

TPMS Reset Instruction 1

Procedure using another Properly Formatted TPMS Scan Tool

Sensor Relearn Procedure:

  1. Inflate all tires to pressure listed on tire placard.
  2. Turn ignition to the OFF position and press and release brake pedal.
  3. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position.
  4. Press and release brake pedal.
  5. Turn ignition to OFF position.
  6. Cycle ignition from the OFF to RUN position 3 times, ending in the RUN position. The horn will sound once, and the TPMS telltale will blink, once relearn mode is initiated.
  7. Starting with the LF tire, use your TPMS scan tool to scan each sensor in the following order: LF, RF, RR LR (and full size spare if equipped). The horn will sound after each sensor is activated.
  8. After relearning the LR tire, the message center will display TRAINING MODE COMPLETE. If the vehicle in not equipped with the message center display, successful completion can be verified by turning the ignition to the OFF position and not hearing the horn sound. If the horn sounds, then the relearn procedure must be repeated.
  9. Turn the ignition to the OFF position

TPMS Reset Instruction 2

No special tools are required to perform this procedure, however a properly formatted

TPMS scan tool may expedite the relearn process.

Sensor Relearn Procedure without a Scan Tool:

  1. Inflate all tires to the pressure listed on the placard.
  2. Turn the ignition to the ON position, then the OFF position.
  3. With the ignition OFF, wait 15 minutes.
  4. Drive the vehicle for at least 10 minutes at a speed of 30 MPH or more for the system to learn the new sensor IDs.

Sensor Relearn procedure with a Scan Tool:

  1. Inflate all tires to the pressure listed on the placard.
  2. Starting with the LF tire, use a properly formatted scan tool to scan each sensor in the following order: LF, RF, RR, LR (and full size spare if equipped).
  3. Turn ignition to the ON position.
  4. Connect the scan tool to the vehicle’s OBDII Port and upload the sensor IDs.
  5. Turn the ignition to the OFF position.
  6. Drive the vehicle above 30 MPH, for at least 5 minutes, and monitor the low tire pressure monitor to ensure it does not blink.

INDIRECT

This vehicle’s TPMS is Indirect which functions using the ABS wheel speed sensor. There is not a TPM sensor in the tire.

 

By erwincsalarda

Hello, my name is Erwin Salarda, and I'm from the Philippines. My main interests are computers and automobiles, and I am very enthusiastic about learning new things in life. Everything on my website was created with the intention of sharing it with you.